WASHINGTON — The battery woes that have indefinitely grounded Boeing 787s have raised questions about how the Federal Aviation Administration (FAA) certified the cutting-edge aircraft.
But few may realize it was Boeing, not FAA inspectors, that largely vouched for the Dreamliner’s safety.
The tests on the lithium-ion batteries at the center of Boeing’s unprecedented crisis were conducted by the company. And the people the FAA designated on its behalf to ensure that the batteries conformed to its safety regulations also were Boeing employees.
That shift toward “self-certification” accelerated during the past decade even as critics say advances in aerospace technologies have created greater need for closer independent scrutiny. Under streamlining begun in 2005, the FAA has granted Boeing in-house oversight for new planes in production and approval of major repairs and alterations.
- Seattle fifth-graders will get their camp trip, but teachers refuse to go
- Designed in Seattle, this $1 cup could save millions of babies
- Five things to watch as Seahawks begin OTAs Monday
- What the national media are saying about Robinson Cano and the Mariners' hot start to the season
- Ivar’s looks to sell, lease back two venerable restaurant sites
Most Read Stories
In a 2011 review, the inspector general of the Department of Transportation found the FAA in one case delegated some 90 percent of the determination for regulatory compliance for new aircraft design to outside representatives. The Inspector General’s Office would not identify the company, but the report focused on Boeing, Cessna Aircraft and Bombardier-Learjet.
The FAA is examining its own certification of the 787 in 2011, even as an international probe continues into what caused a fire and another battery malfunction last month that sidelined Boeing’s new flagship jet.
Bret Jensen, a spokesman for Boeing, responded that the 787 was subject to greater scrutiny from the FAA than any previous jetliner.
“We are confident in the regulatory process that has been applied to the 787 since its design inception and we are confident in the safety and quality built into our products,” he said.
Critics say the FAA’s heavy reliance on manufacturers to attest to the safety of their own products has largely relegated the agency to an administrative role — and has left it without the expertise and manpower to adequately challenge and revise safety standards.
For example, the FAA allowed Boeing more than three dozen deviations from existing safety requirements for the composite-frame 787. Called Equivalent Levels of Safety, they were Boeing’s alternative proposals for complying with regulations concerning fuel-tank flammability, auxiliary power unit installation and other design and operational matters.
The FAA issued so many exceptions for the 787 that it “represents an aircraft that sort of meets the regulations,” contends Michael Dreikorn, principal partner at ASD Experts, an aviation consulting firm in Bokeelia, Fla.
Dreikorn, a former FAA official who was vice president of quality and regulatory compliance for jet-engine maker Pratt & Whitney, believes the FAA should have applied more of its own expertise and direct oversight to the 787’s many new technologies. Dreikorn has been a paid expert in a whistle-blower lawsuit filed by Boeing employees in Wichita, Kan., claiming manufacturing defects in some 737-Next Generation planes.
One question now is whether FAA engineers adequately gauged the risks posed by the 787 battery, which the agency called a novel technology. The FAA approved its use in 2007 — four years after Boeing first applied to build the jet — but attached nine conditions to reduce potential hazards.
Lithium-ion batteries are well known for being much more flammable than older nickel-cadmium batteries, with fires that are all but impossible to extinguish until a battery’s solvent-based liquid electrolytes burn out.
Among other things, the FAA required the battery design to prevent the possibility of spreading, uncontrolled overheating. That danger, known as thermal runaway, is exactly what occurred in the first of two 787 incidents, when a fire broke out aboard a Japan Airlines 787 after it landed in Boston’s Logan Airport on Jan. 7. The National Transportation Safety Board (NTSB) said the battery showed signs of short-circuit and thermal runaway.
The FAA also had decreed that any battery malfunction not damage surrounding electrical systems and equipment enough to cause a more serious failure. Yet the Japanese plane sustained damage to the adjacent electronics bay, although the NTSB has yet to determine whether the battery — located beneath the cabin in the plane’s rear and accessible only from the outside — could have disabled critical flight controls had the fire occurred in midair.
Mary Schiavo, former inspector general for the Transportation Department, said the FAA’s extra safeguards for the battery instead turned out to be a blueprint for malfunctions.
“This regulation predicted that this would happen,” Schiavo said.
She questioned the FAA’s decision to “contain a failure, not eliminate it.” She contends the agency perhaps should have pushed Boeing harder to consider alternatives to lithium-ion technology.
According to the FAA, Boeing’s battery tests were observed by both company employees and agency staff. Some of the Boeing employees were acting as representatives of the FAA because Boeing has what’s called an Organization Designation Authorization (ODA) to act as proxy on certification oversight.
From the early days of commercial aviation, the FAA has relied on third-party observers to ensure aircraft were designed, engineered and produced according to regulation. But partly in response to complaints about a slow and inefficient certification journey, the FAA has shifted even further away from detailed product oversight to focusing on overall systems safety.
The creation of the ODA system was one big change. Under it, Boeing became an FAA designee with wide latitude in picking the company’s own engineers to sign off on their employer’s work on behalf of the FAA. Previously, engineers in that role were approved by and reported directly to the FAA.
Bart Crotty, an aviation-safety consultant in Springfield, Va., said the FAA lacks the technical firepower to directly inspect every stage of getting a new aircraft in the air. So it’s left to the manufacturers’ employee engineering delegates to review the design, plan and observe tests, and certify they meet applicable standards.
FAA staff will attend many critical tests involving safety issues — such as flammability of new materials and design of flight controls — especially before the initial “type certificate” is issued for a new jet model. If they witness something questionable, FAA employees can refuse to sign off on a certificate, Crotty said.
But for the most part, the FAA’s role is largely administrative, such as overseeing data recording. In fact, FAA employees don’t conduct any hands-on inspections because of liability risks, said Crotty, who is a former industry designated airworthiness representative.
And once the manufacturer receives a production certificate greenlighting assembly, “the FAA becomes a ghost,” he said.
Boeing’s Jensen said ODA is not tantamount to self-certification. Instead, he said, Boeing’s authority extends only to “routine compliance activity where we have the expertise and have demonstrated the capability,” with the FAA retaining ultimate authority.
Jensen said Boeing is not disclosing how many battery tests it ran or other details.
Dreikorn, the former FAA official, doesn’t believe the FAA ought to subsidize private research by conducting separate tests. Still, he contends the FAA wasn’t quick or rigorous enough in anticipating troubles with the new lithium-ion technology.
The FAA’s conditional approval for the 787 battery came a year after a three-alarm fire in Tucson, Ariz., in 2006 leveled a building where the company that makes the battery’s charging-control system was working with a prototype.
In an incident in 2011, a new Cessna Citation business jet caught fire at that company’s plant in Wichita, Kan., while its lithium-ion battery was being recharged. Cessna quickly decided to swap out the battery with nickel-cadmium versions that are less prone to ignite. That did not prompt the FAA to revise its special conditions on the 787 battery. According to the FAA, the design of Cessna’s lithium-ion battery was different from Boeing’s. Besides, the FAA said, the Cessna fire was caused by a mechanic who bypassed safety controls.
Dreikorn said that wasn’t good enough.
“The FAA should have cast a very large shadow over the (787) design and certification processes. But, without the right expertise, the shadow does little good,” he said.
If Boeing turns out to have made technical mistakes or followed regulations with less than absolute diligence, he said, “the FAA allowed them to do it.”
Kyung Song: 202-383-6108 or email@example.com