Bead must be 100 percent clean to be properly seated.

Share story

Dear Car Talk: Since replacing the tires on my car 18 months ago, I’ve experienced several flats. The tires are Goodyear Fuel-Max. When I bring the car back to the tire shop, they inspect the tire and find no puncture. The only reason the mechanics at the shop and I can come up with is that the bar-code labels positioned along the bead of the tire are causing the seal to break. Could there be any other reason?
— Frank

A: There shouldn’t be any bar-code labels on the bead, Frank. The bead is supposed to be 100 percent dead clean when you mount the tire. Otherwise, the tire won’t seat properly, and air will leak out.

So there’s nothing permanently embossed on or etched into the tire that interferes with the bead. And if there’s a removable label of some kind that came with the tire, the installer should have removed it.

If not, that’s a real rookie mistake, and that’s on him.

Assuming the bead was, in fact, clean when the tire was mounted, then you’d look for either a bad air valve or some problem with the rim that was preventing the tire from seating properly.

On an older car, that could be rust or corrosion. Or on a car of any age, it could be a bent, warped or cracked rim; I doubt the problem is with the tires themselves.

So if you’ve been back to the installer more than once with non-punctured flat tires, have them remove and remount the tires.

While the tires are off, they can check again and make sure there are no dents or corrosion along the beads that are causing your leaks.

Or if they find a price tag there, they can discreetly remove it.

Got a question about cars?
Contact Ray  through the website
cartalk.com.